146-ENF_Flexible_filler_kit
115-High-temp_silicone_sealant

Stove Silicone and Silicone Tape

From £3.98 to £58.48

no-image-available

Board Sealant

£7.88

Sealant System For Pipes And Cables

From £8.37 to £21.73

Powerful intumescent sealant for sealing voids around services passing through fire-rated surfaces. (PRODUCT 146)

SKU: PRODUCT 146
Category:

Share on:
  • Description
  • APPLICATION INSTRUCTIONS
  • DOWNLOADS
  • ORDER REFERENCES

Description

A new dual-sealant system suitable for aluminium, steel, copper, and plastic pipes and cables in openings up to 50mm diameter. (For larger openings, see Product 13 WPCS Range). Tested in a plasterboard wall, achieving 96 minutes fire rating. The kit comprises three 310ml tubes of water-based sealant (two tubes of dark grey sealant and one white finishing sealant). When cured, the. sealant is not affected by water. The EN/F sealant kit is designed for use in both plasterboard and solid substrate surfaces (brick/block/concrete). See new data sheet for more information. The dark grey EN/F1 filler is also available separately in 310ml tubes.

 

ADVANTAGES

  • Suitable for use with aluminium, copper, plastic and steel pipes up to 50mm diameter
  • Can also be used for cables (including armoured cables, MICC and flexible cable types) up to 32mm diameter
  • EN/F2, our white intumescent sealant, is ideal for use as a decorative finish and comes as part of the EN/F Kit
  • Both EN/F sealant types are made of water-based materials which become water-resistant once cured

 

FIRE TEST PERFORMANCE

Tested to EN 1366-3 (2009).

APPLICATION INSTRUCTIONS

The cartridges marked EN/F1 (the dark grey intumescent graphite compound) are for filling around theservices from 30mm into the hole and up to 10mm from the front surface. The cartridge marked EN/F2 (the white intumescent sealant) is used to fill the gap from the grey material to the front surface of the plasterboard or block wall. The surface can then be levelled using a decorator’s spatula. Once cured, the surface material can be painted over.

PLASTERBOARD: In plasterboard walls the hole must be 40mm larger in diameter that the services passing through. For example, a 50mm diameter pipe would require a hole size 90mm in diameter.

SOLID SUBSTRATE: For brick, block and concrete ceilings and walls the hole must be 30mm larger in diameter than the service. For example, a 50mm diameter pipe would require a hole size 80mm in diameter.

DOWNLOADS

Please use the links below to download relevant information as PDF documents:

 

Technical Information

TD146-07-2014

 

Application Instructions

AP146-07-2014

 

COSHH Data

HS146-07-2014

ORDER REFERENCES

REF CONTAINS
EN/F1 1 x 310ml tube (dark grey)
EN/F Kit 2 x 310ml tube (dark grey), 1 x 310ml tube (white)

 

Related Products